This book provides selected papers presented at the 1st International Conference on Mechanics of Solids, held in Porto, Portugal, November 3-4, 2022.
The book focuses on the mechanics of deformable solids, dynamics of particles and rigid bodies. Topics like mechanical behaviour of materials, mechanics of composite materials, plasticity, fracture mechanics, and optimum design methods are covered. This volume provides the latest trends related to mechanics of solids and appeals to researchers and practitioners across the broad spectrum.
Part I. Mechanical behaviour of materials.
Chapter 1. Effect of partial
replacement of cement with waste granite powder and quartz powder on the
compressive strength of hardened mortars for cement masonry (Woniak).-
Chapter 2. Towards Modification of Polyurethane Paint Coatings for Softwood
Protection: Preliminary Studies of the Use of Multi Walled Carbon Nanotubes
(Brzozowska).
Chapter 3. Role of SiC Powder in Reducing the Porosity and
Increasing the Carbon Content in Wire Arc Additive Manufacturing of Carbon
Steel.- Part II. Mechanics of composite materials.
Chapter 4. Fracture
toughness analysis of polymer concretes made by waste mineral aggregates and
enhanced with glass fibers and metal chips.- Part III. Plasticity.
Chapter
5. Effect of flower pattern design on the springback of high strength steel
in cold roll forming process of pipes (Firouzjaei),- Part IV. Fracture
mechanics.
Chapter 6. Mixed-mode I/II fracture load prediction in cracked
rock geometries using the tangential stress contour (TSC) method (Bidadi).-
Part V. Optimum design methods.
Chapter 7. Investigation of Geometries and
Stability for Increasing the Energy Density in Electromechanical Battery
Flywheels.
António J. M. Ferreira is Professor of mechanical engineering at the University of Porto, Portugal. He is mainly engaged in the research of composite materials and has high attainments in the field of composite mechanical engineering.
Lucas F. M. da Silva is Full Professor in the Department of Mechanical Engineering at the Faculty of Engineering of the University of Porto (FEUP). He leads the Advanced Joining Processes Unit (AJPU) of the Institute of Science and Innovation in Mechanical Engineering and Industrial Engineering (INEGI).
Biežāk uzdotie jautājumi par e-grāmatām